Panel-mounting rack

Highlights

• very short assembly time because of maximum prefabrication and simple positioning

• joints and fastenings are reduced to a minimum (only two sizes of spanner)

• durable, stable and reusable

• there are hardly any tensions in the system and therefore few in the modules too

• no diagonal struts are necessary: minimizes the effort involved with assembly

• the framework can be erected on several types of foundation (screwed piles, rammed piles or concrete foundations)

• a thin layer or crystalline with three supports is possible: no increase in the number of supports is needed

• the framework can also be used in a ’half-table‘ configuration

• the system's statics are supplied (adapted to the respective building site)

• coordinated components

• every inclination angle is possible in the field (must be stated when ordering)

• almost free of maintenance

Possibilities (examples)

• module size of 1.60 m x 0.80 m (e.g., crystalline):   4 x 8 = 32 units.

• module size of 1.20 m x 0.60 m (e.g., amorphous): 5 x 9 = 45 units.

Load-bearing construction

• steel, galvanized according to DIN EN ISO 1461 / 1471 3

• wind loads according to DIN 1055 or the customer's specific requirements

• aluminium middle clamps and end clamps, so that the modules can be fastened according to the manufacturer's instructions (at the specified load-transfer points)

Module's load-bearing construction

• homogeneous construction: the modules lie on aluminium rails: there is therefore no difference in the thermal expansion coefficient of the module's load-bearing construction (module's framework, clamps and rails).

Foundation work - several types of foundation

Concrete foundations:

• reinforcement takes place according to structural calculations; the feet are fixed with dowels or pins

Screwed piles:

• steel, galvanized according to DIN EN ISO 1461 / 1471 3

• loadable directly after screwing; no ground sealing (i.e., waterproofing); subsequent dismantling and restoration are possible without any problems

Rammed piles:

• steel, galvanized according to DIN EN ISO 1461 / 1471 3

• loadable directly after ramming; no ground sealing (i.e., waterproofing); subsequent dismantling and restoration are possible without any problems